yesterday i installed my e3 flasher cause my ps3 bricked when i installes a mfw pup with the tcl adddon shutdown system if lv2 modification is detceted and that bricked my ps3,now everytime put it on it use to stay on and i had to hard reset it.but b4 my ps3 bricked i took a a backup of my nor using the dump nor pkg app.so now as i got the flasher i put that same dump onto the sd card and it gave me error at first,then i realised that the sd card wasnt being read properly so i fixed that and then it began to install the dump but when it was finish it showed me 7 led instead of 8 and now my ps3 goes back off when i put it on and i have to press the power button twice to pput it on and it just goes back off and also the wire i soldered broke off from the sbe on the flex cord so is there anyway at all i could solder somewhere else to recover my ps3.plz thanks in advance.
And also when i flash the ps3 with this dump using the flasher,when it was done i took a look at the log file and everything when fine at the end of the log it said ps3 nor is ok.
here is the dump i got from the dump pkg app can someone plz test it for me:http://www.mediafire.com/?3ux68brsgt1x34e
And also when i flash the ps3 with this dump using the flasher,when it was done i took a look at the log file and everything when fine at the end of the log it said ps3 nor is ok.
here is the dump i got from the dump pkg app can someone plz test it for me:http://www.mediafire.com/?3ux68brsgt1x34e