Hello,
i need help with progskeet and the 360clips NOR
I have progskeet 1.1 and the last one 1.21
i modified my progskeet 1.1 like on Ultimate Fool Proof Guide
and i solder a wire from progskeet 3.3v to the clips
but i can't dump the nor i try with the progskeet 1.21 without modification and the same result
:questionmark: :questionmark: what i need to do now :questionmark: :questionmark:
i need help with progskeet and the 360clips NOR
I have progskeet 1.1 and the last one 1.21
i modified my progskeet 1.1 like on Ultimate Fool Proof Guide
and i solder a wire from progskeet 3.3v to the clips
Quote:
|
1. With the Blue Boards there are 2 jumpers to create (bridge). for both white & blue boards there is 1 resistor to remove. The areas in YELLOW circles (R9 & R 11 the 3.3v setting) need soldering (bridge). And in RED Circle the R7 needs the resistor removing. Nb if you heard about removing R8 this is old news and needs to remain attached now. |
:questionmark: :questionmark: what i need to do now :questionmark: :questionmark: