[Q] NAND read/write with teensy++

@judges
You recently released the NAND signal boost but I'm kinda lost.

I soldered using the "Alternative NAND pins by Jestero" (Only on side B for testing purposes), and I'm unable to read the NAND. On the my teensy++ no light comes up when I connect the usb since flashing the new Hex (From the link above). I can hear windows making the new device plugged in beep, but no light. I cut the +5v line and bridged the +3v line. I didn't install the regulator and the NAND is powered by the PS3 (I power on the PS3).

I typed:

nandway.py COM6 0

and

nandway.py COM6 1

and I get "pinging...." and it closes.


So my question is.

1) If im going to power on the ps3 (have the tristate connected to gnd), do I need the voltage regulator?
2) Do the lights turn on, on my teensy++ when I power it from the usb without the vregulator?
3) Can I use the new Hex to downgrade this ps3, or do I need to flash the one on Git?

Thanks.