I researched this both on here and on google and got nothing, so if someone could point me to a thread where this is documented, that would be much appreciated.
If there is no thread, this is the problem.
First let me say that I have been soldering for quite a few years, just most of that is not with PCB boards, it was mainly batteries, motors, much bigger stuff. I was soldering wires to my jsd motherboard slim ps3 to then attach a progskeet and flash a new firmware to my ps3.
While soldering, I got to doing the last few wires. While trying to access a point, I bent another wire out of the way of the point, and the wire also came off of the motherboard. There is no solder left on the motherboard and none will stick either.
If it makes a difference, it was the A9 testpoint on a jsd motherboard.
Does anyone have any advice to get some solder back on this point?
Also thanks so much in advance!
If there is no thread, this is the problem.
First let me say that I have been soldering for quite a few years, just most of that is not with PCB boards, it was mainly batteries, motors, much bigger stuff. I was soldering wires to my jsd motherboard slim ps3 to then attach a progskeet and flash a new firmware to my ps3.
While soldering, I got to doing the last few wires. While trying to access a point, I bent another wire out of the way of the point, and the wire also came off of the motherboard. There is no solder left on the motherboard and none will stick either.
If it makes a difference, it was the A9 testpoint on a jsd motherboard.
Does anyone have any advice to get some solder back on this point?
Also thanks so much in advance!