i have a bricked PS3 on the 3.55 OFW (i have bought a PS3 with rogero CFW , this PS3 have been downgraded ).
i have installed from recovery mode the 3.55 OFW without QA flaging it and got the semi bricked ).
i don't have any bios back up from my ps3 before the brick , so i tried to pick up a new back up from it acctually using the E3 clip, but i always have the error 10001100, i tired to follow this link to avoid this message :
http://www.ps3hax.net/showthread.php?t=35268.
but unfortunately i have always the same error message .
the PS3 mother board is a JSD-001 with a nor Spansion :
http://www.ps3devwiki.com/images/1/1...-progskeet.jpg.
Following this link :
http://www.ps3hax.net/showthread.php?t=34372.
I have managed to soldier the E3linker directly to avoid the error message but it seams that i have done some mistakes .
i have folowed the picture in this link to soldier :
http://www.ps3devwiki.com/images/1/1...-progskeet.jpg.
should i :
1- soldier the VCC and BVCC from the linker to the 3.3V VCC mother board indicated on the picture below http://www.ps3devwiki.com/images/1/1...-progskeet.jpg. ( there is a second VCC on this picture, http://www.ps3devwiki.com/wiki/File:...testpoints.png )
2- soldier CE and SBCE from the E3linker to the GP0 ( CE) of the mother indicated on the pic http://www.ps3devwiki.com/images/1/1...-progskeet.jpg.
![]()
i have installed from recovery mode the 3.55 OFW without QA flaging it and got the semi bricked ).
i don't have any bios back up from my ps3 before the brick , so i tried to pick up a new back up from it acctually using the E3 clip, but i always have the error 10001100, i tired to follow this link to avoid this message :
http://www.ps3hax.net/showthread.php?t=35268.
but unfortunately i have always the same error message .
the PS3 mother board is a JSD-001 with a nor Spansion :
http://www.ps3devwiki.com/images/1/1...-progskeet.jpg.
Following this link :
http://www.ps3hax.net/showthread.php?t=34372.
I have managed to soldier the E3linker directly to avoid the error message but it seams that i have done some mistakes .
i have folowed the picture in this link to soldier :
http://www.ps3devwiki.com/images/1/1...-progskeet.jpg.
should i :
1- soldier the VCC and BVCC from the linker to the 3.3V VCC mother board indicated on the picture below http://www.ps3devwiki.com/images/1/1...-progskeet.jpg. ( there is a second VCC on this picture, http://www.ps3devwiki.com/wiki/File:...testpoints.png )
2- soldier CE and SBCE from the E3linker to the GP0 ( CE) of the mother indicated on the pic http://www.ps3devwiki.com/images/1/1...-progskeet.jpg.